Here you can also choose to remeasure a specific speaker at any of the microphone positions. If you’ve chosen more than five microphone positions or take multiple measurement sets, the window expands to show all relevant measurements. By default, the software measures five microphone positions and shows five panels in this window. With the Review and/or Remeasure screen, you can view the original (unaltered) measurements for each speaker at any microphone position. These instructions vary depending on the model of the ARC-compatible microphone. Please pay careful attention to the onscreen instructions during this process. This process repeats for the remaining measurement positions (we recommend measuring five locations for most rooms). Move the mic to position 2 as per the onscreen instructions, click Resume, and the tones cycle through the speakers again. After the position 1 tones finish, you’ll see the mic position on the diagram move to position 2. This step plays a series of tones through each speaker channel and captures the resulting output for use when calculating ARC corrections. Put the mic into position 1 and click Start. Place the stand on the floor or the seat according to whichever way puts the microphone in its proper position. Adjust the height by first loosening the clamps on the telescoping tube and the arm.Connect the USB cable to the microphone and slide the mic into the clip.Screw the microphone clip to the other end of the stand.Loosen the tripod base screw, move the base to the bottom of the telescoping tube, and re-tighten the screw.
0 kommentar(er)
